Bomb Factory Plug-ins Guide56
Additional Controls
Though the Voce Spin plug-in window contains
only the Chorale/Off/Tremolo control, the fol-
lowing parameters are also available:
•Input Trim
• Speed Switch
• Rotor Balance
• Upper Slow Speed
• Upper Accel Rate
• Upper Decel Rate
• Upper Mic Angle
• Lower Fast Speed
• Lower Slow Speed
•Lower Accel Rate
•Lower Decel Rate
• Lower Mic Angle
Using these controls, you can adjust and auto-
mate parameters such as input trim (from
–24 dB to +24 dB), set the rotor balance (the mix
between the upper and lower speakers), specify
acceleration and deceleration times (in seconds)
for both the upper and lower speakers, tweak the
fast and slow speeds of each speaker, and specify
the microphone angle for each stereo pair of mi-
crophones.
You can access these additional controls
through Pro Tools plug-in automation, and/or
from a compatible control surface.
Accessing Controls On-Screen
All Voce Spin parameters can be adjusted on-
screen by editing Pro Tools breakpoint automa-
tion data.
To access additional Voce Spin parameters on-
screen:
1 Click the Plug-in Automation button in the
Plug-in window to open the Plug-in Automation
window.
2 In the list of controls at the left, click to select
a control and click Add (or, just double-click the
desired control in the list). Repeat to access and
enable additional controls.
3 Click OK to close the Plug-in Automation win-
dow.
4 In the Edit window, do one of the following:
• Click the Track View selector and select the
automation control you just enabled from
the Voce Spin sub-menu.
– or –
• Reveal an Automation lane for the track,
click the Automation Type selector and se-
lect the automation control you just en-
abled from the Voce Spin sub-menu.
5 Edit the breakpoint automation for the en-
abled control.
To Next Page
Loading...
Need help?
General
