PRE Guide34
Control|24
Control|24 provides two modes of Mic Preamp
remote control: Channel-Wide Gain Control
and Individual Channel Control.
Channel-Wide Gain Control Mode
This mode dedicates the Control|24’s Data En-
coders for changing gain level on any Mic
Preamp in Pro Tools that has been mapped to a
physical input which is assigned to an input
path that one of the tracks in the session is us-
ing.
For each channel with a Mic Preamp, the LED
ring around the encoder displays an approxima-
tion of the current input gain value. The 4-char-
acter display above each encoder shows the Mic
Preamp number (based on their order in the pe-
ripherals dialog), or level, in dB. This display can
be toggled with the SHOW VALUES button. Val-
ues are also shown when the encoder is ad-
justed.
The REMOTE MIC PRE button enables this
mode (or returns Control|24 to its previous op-
eration mode). When enabled, the REMOTE
MIC PRE LED is lit, and the Channel Bar Display
updates with the following message: “MIC PRE.”
To set input gain using Channel-Wide Gain Control
mode:
1 Press REMOTE MIC PRE.
2 Rotate an encoder until the desired gain level
is displayed. (To view a level before adjustment,
press SHOW VALUES.)
To exit Global mode:
Press REMOTE MIC PRE.
Individual Channel Mode
This mode dedicates the Control|24’s Data En-
coders 1–8 for control of all parameters of Mic
Preamps in Pro Tools that have been mapped to
a physical input which is assigned to an input
path that one of the tracks in the session is us-
ing.
For the current Mic Preamp channel, the 4-char-
acter displays above encoder scribble strips 1–8
show the Mic Preamp parameter or value. The
display can be toggled with the SHOW VALUES
button. Values are also shown when the encoder
is adjusted.
When Individual Channel mode is active, Data
Encoder scribble strips 1–8 display Mic Preamp
status, as follows:
• If the channel with focus has a Mic Preamp,
the display updates with PRE parameter
names or values (see the table, below).
• If the channel with focus does not a have a
Mic Preamp, the LED display updates with
the following message: “No Mic Pre As-
signed To This Channel.”
To Next Page
Loading...
Need help?
General