Chapter 3: Remote Operation 33
To change a Mic Preamp parameter:
1 Press F2 to enable the DSP Edit/Assign section
for Mic Preamp control.
2 Press a channel INS/SEND switch. The Mic
Preamp name is displayed in the CHAN-
NEL/GROUP display. Channel focus is indicated
in Pro Tools by a red outline around the track
name.
3 Do any of the following:
• To change input gain, line source or imped-
ance, rotate the corresponding data en-
coder to scroll through the available
choices.
– or –
• To change parameters with two states
(On/Off or In/Out), press the correspond-
ing IN/OUT switch.
4 To switch to another channel for additional
Mic Preamp editing, press the corresponding
track INS/SEND switch.
To exit Individual Channel mode:
1 Press F2 again, or do one of the following:
• Press any channel EQ IN/EDIT or DYN
IN/EDIT switches. These switches are lo-
cated along the top of the Fader section.
• Double-press any channel INS/SEND
switch.
• Press either the INSERTS/PARAM or SENDS
switch (in the DSP EDIT/ASSIGN section).
• Press the Master Faders switch.
If you press F2 again to leave Mic Preamp mode,
ProControl reverts to its previous state.
Resetting Defaults
Mic Preamp defaults can be reset from ProCon-
trol (while in Individual Channel mode), as fol-
lows:
To reset a channel’s input gain (to 0):
1 Press F2 to enable the DSP Edit/Assign section
for Mic Preamp control.
2 Press a channel INS/SEND switch to focus a
channel. This should be a channel with a Mic
Preamp.
3 Press DEFAULT+BYPASS IN/OUT for the pa-
rameter you wish to reset to defaults.(DEFAULT
is located in the upper left-hand corner of Pro-
Control, BYPASS is located next to each parame-
ter in the DSP Edit/Assign area.
To reset all the parameters on a channel to their
defaults:
1 Press F2 to enable the DSP Edit/Assign section
for Mic Preamp control.
2 Press a channel INS/SEND switch to focus a
channel.
3 Press DEFAULT+MASTER BYPASS. (DEFAULT
is located in the upper left-hand corner of Pro-
Control, MASTER BYPASS is located to the right
of the CHANNEL GROUP display.)
To simultaneously change settings in multi-
ple PRE channels, first press and hold
SHIFT/ADD while selecting channels using
the Select button on each track (or Shift-
click track names in Pro Tools), then press
and hold SHIFT+OPT while making adjust-
ments.
To change settings in all channels, press
and hold OPT while making adjustments.
To Next Page
Loading...
Need help?
General