Digilock Curve Keypad Basic - Lock Testing

INSTALL GUIDE
Keypad & RFID
|
Basic & Advanced
9
RFI D
CARD
RFI D
CARD
To ensure functionality after installation, it is recommended that the lock is tested with the door open�
Repeat test with the door closed.
If ten rapid beeps are heard, the strike plate or door alignment may need adjustment to allow the lock to operate properly.
If the door does not lock when the bolt/latch is extended, the strike plate or lock position may need adjustment.
Press
= `
to extend the bolt.
Press
= `
again to retract the bolt.
Press
= `
to retract the latch.
The latch will extend automatically.
Present any RFID card to reader to extend the bolt.
Present the same RFID card to reader again to retract the bolt.
Present any RFID card to reader to retract the latch.
The latch will extend automatically.
For touch-free RFID locks with deadbolt rear units:
For touch-free RFID locks with deadlatch rear units:For keypad locks with deadlatch rear units:
For keypad locks with deadbolt rear units:
LOCK TESTING INSTRUCTIONS