The Beeper Intensity can be adjusted from 0-10. 0 is off, 1 is a
small, infrequent chirp and a 10 is a frequent, loud beep.
The factory default is 4. If you have multiple pits, this feature
is useful for distinguishing one pit from another, by giving
each one a unique beep duration.
10.3 Beeper Intensity
10.4 Open Lid Detect
15
This feature will allow quick recovery to the setpoint temperature after the lid
is opened. When the open lid is set to (open lid yes), open lid detect is
enabled. When the lid is opened, the temperature will drop. This can cause
the fan to over-fire the coals and cause overshoot when the lid is shut. This mode
detects when the pit’s lid is open and minimizes the fan running during that time.
Some overshoot will always be present when the pit’s lid is opened and
closed even if the fan is off, because it still introduces oxygen to the fire. The
factory default is , so disable this feature if there are problems with excess
air currents in the pit. To disable this feature, set it to (open lid no). To
prevent false alarms, the alarm will not sound when the temperature drops and
the lid is open.
OPEN LID DETECT – OVERSHOOT ELIMINATOR
When the open lid detect is enabled, the rate that the temperature rises in the
pit will be limited, preventing over-firing. This will make a typical startup to a
temperature of 250 degrees F take a minimum of 20 minutes and will help to
eliminate startup overshoot.
To Next Page
Loading...