DIGIQUEST
2
SAFETY INFORMATION
CAUTION: to reduce the risk of fire and
electric shock, do not open the unit. All
work must be carried out by a specialised
technician. Opening the receiver will
automatically void the warranty.
This symbol
indicates dangerous voltage
inside the product, which may cause
electric shock and personal injury.
This symbol indicates that there
are important instructions
accompanying the appliance.
CAUTION: the only way to disconnect the decoder from the
mains is to remove the plug from the outlet. Make sure that the
power outlet is easily accessible, so that you can easily disconnect
the product if necessary. Read the manual carefully before using the
decoder. Keep the instructions for future reference. Do not open the
unit and/or the power supply, touching the internal components may
cause electric shock. Contact with a voltage of 100-240V~ can be
fatal. Before connecting the decoder to the power supply, make sure
that all connections have been made correctly. Always unplug the
decoder from the power outlet before connecting or disconnecting the
cables. Failure to observe these precautions can result in damage,
fire or electric shock, which can result in serious injury!
POWER SUPPLY. If the model you have purchased requires a power
supply unit, you must use the power supply unit supplied with the
decoder to prevent damage to the unit. The use of a power supply
other than the one supplied with the decoder will automatically relieve
the manufacturer of all liability. Check that your power supply
corresponds to that required for operation (see label on product or
product specifications). Consult your energy manager if you are
unsure of the features of your power supply. Do not attempt to repair
or splice the power cord. Do not tamper with the power cord or plug.
Make sure the power cord is not damaged, knotted, or pinched before
use. It is recommended to disconnect the decoder from the power
supply when not in use for a long period of time, during thunderstorms
or special events. Never unplug the unit from an outlet by pulling on
the cable. Do not connect or disconnect with wet hands or bare feet.
Do not use objects such as levers to disconnect the plug from an
outlet. The power cord should be protected by a plastic cover to
prevent it from being damaged or walked on. If you smell burnt or
smoke, unplug the power cord immediately and contact your service
representative.
SHOCK
To Next Page
Loading...
