DIGIQUEST
10
□□□□
Enter your PIN again in Confirm Password. ATTENTION: if you make a
mistake in entering the confirmation password, you will be able to repeat
the procedure after a few seconds. Go to Next and press the OK button
to go to the next screen. Choose TV System (Auto, PAL, NTSC), Video
Resolution (according to your TV), Screen Format: choose the one
suitable for your TV. Select Next and press OK to go to the next screen.
FTA: if you leave Yes, only Free to Air channels will be loaded. If you
choose No all available channels will be loaded.
LCN: On/Off. Search with automatic channel sorting.
Go to Next and press OK to start the Automatic Channel Search.
You can exit the scan at any time by pressing EXIT on the remote
control and confirming. At the end of the channel scan, a channel
positioning conflict may occur: in this case a window will appear in which
the channels found on two or more different frequencies will be listed. If
the position proposed by the decoder is the desired one, just wait without
pressing anything. If you want to change the channel to be stored, use
the and keys to move to the desired channel and press OK. You can
also select Resolve automatically and allow the decoder to save
channels automatically. MPORTANT: during the waiting process, DO
NOT perform any operation (e.g. press remote control buttons, turn off
the receiver, disconnect the power supply), wait for the receiver to
automatically position itself on a channel. NOTE: the installation
procedure can be repeated over and over again, just reset the receiver:
- Enter the Main Menu (MENU button).
- Press the or key to go to System menu and press the key to go to
Factory settings. Press OK key and confirm whether or not to reset the
decoder to Yes or No with the or key and press OK.
WARNING: when the decoder is reset, all settings entered by the
user will be lost.
MENU
Press MENU button to enter the menu. The menu contains the following
submenu: Channel List, Channel Search, Language, AV setting, Local
Time Setting, System, Multimedia, Network.
Use the or keys to move to the desired position and use the
key to enter the submenu (window below) and move to the desired
position. Press OK to enter. Press MENU or EXIT key to return one
step.
To Next Page
Loading...
