DIGIQUEST
14
Wakeup Date: set Wakeup Date by pressing numeric button.
On Time: set On Time by pressing numeric button.
End Time: set End Time by pressing numeric button.
Save: move to the Save box and press OK to save the set timer.
To delete a set timer, select it and press the GREEN key, then press
EXIT and confirm or not to save. To modify an already programmed
event, press the YELLOW key.
NOTE: When setting a timer, it is recommended to disable the Update
functions, see the following chapters.
OSD Setting
- OSD Timeout: 3~10.
- OSD Transparency: when set to 00 the OSD screens cover the whole
screen, when set to 10 / 20 / 30 / 40 the screens gradually show the
image below.
- Switching Mode: Video Freeze/Black Screen.
- Subtitle Display: On/Off.
USB Update/OTA Upgrade
This menu allows you to upgrade software version by USB/OTA.
- In System menu, highlight the USB Update or OTA Upgrade, press OK
button to enter the sub menu.
- Press or button to highlight the desired item and press or to
set up.
- Highlight Start and press OK button to update.
Press EXIT or MENU button to back to the previous menu.
Other
- Auto Standby: after 3 hours of total inactivity (no command) the
decoder automatically switches off. If you want to deactivate this
function select Off.
- Automatic Software Update. NOTE: It is recommended to leave the
existing settings in the decoder.
In Standby mode: to enable or disable the automatic update when the
decoder is in standby mode.
In Operate mode: to activate or not the automatic update when the
decoder is on.
Time: press numeric button to set the Time for upgrade automatically.
Repetition: Daily/Weekly
- Automatic Channel Update
For automatic update of the channel list:
In Standby mode: the decoder can search for any new channels
automatically (Active) when in standby mode.
To Next Page
Loading...
