- 16 -
Shift Control
Bracket Mode Screen 6
The Mega 475 can handle up to 5 shifts by time or
RPM in a single pass.
The Selection Arrows on the right side of the screen
are used to show the line that is currently selected.
Use the NEXT key to change the selected line.
Tach
Displays engine RPM when running. When the
engine is not running, displays the Peak RPM. This is the
highest RPM the engine reached, since the last time the Peak
RPM was cleared. Use the CLEAR key, when the engine is
off to clear the Peak RPM.
Shift Point
Use the CLEAR key, then use the NUMERICAL
keys to enter a Shift Point. Or use the or key to increase
or decrease the Shift Point value by one.
Number of Cylinders
Settings of 4, 5, 6, 8, 10, and 12 are available. Use
the or key to select the desired setting.
Shift mode
Use the to select the Shift mode HI or LO. The
Shift Mode can only be changed when Shift 1 is displayed.
Use the ZERO key to change which Shift 1 through 5 is
being displayed. Use the key to select if the shift will be
by time or RPM for the displayed shift.
Press the SET UP key to go to the Dial Display
Intensity Control screen.
To Next Page
Loading...
Need help?
General
