- 46 -
exit the Driver’s Reaction Test Mode after 30 seconds of
inactivity. Each time a push-button is pressed for a practice
hit, the 30 second timer resets.
The Driver’s Reaction Tester can also be used to
check different buttons and button locations for consistency
and speed. Start by getting a reaction time average, at least
10 passes. Then compare with an average from either
another push-button or the same button mounted in a
different location.
NOTE: The CLEAR key can be used to reset the Average
Driver’s Reaction time.
NOTE: When in the Driver’s Reaction Test Mode, the
Transbrake solenoid will not be activated. This is to prevent
any damage to the solenoid from overheating.
To Next Page
Loading...
