Mode of deaw tool road: As for the plane line, such as the PCB engraving or the color plates lettering,
please adopt the line pattern. As for the plane embossment, please adopt the statue pattern.
11) Parameter of MPG function(5 in total)
12) Parameter extended functions (7 in total)
13) Parameter of Backlash (9 in total)
#428 Enable MPG RESET 1 BOOL
BOOL
1/0
1/0
BOOL 1/0
BOOL 1/0
BOOL 1/0
0: Disable,1: Enable
#429 Level of MPG RESET 0 1: High; 0:Low
#430 Type of MPG port 1 0:UART,1: Standard
#431 Pulse of MPG 0
0
0: 100 steps /cycle,1: 24 steps /cycle
#432 IO signal level of MPG 1: High; 0:Low
Para.
Mark
Parameter definition
Default
value
Parameter
Unit
Parameter
Scope
Notes
BOOL 1/0 1: High; 0:Low
BOOL 1/0
BOOL 1/0
BOOL 1/0
1: High; 0:Low
#423 External RESET 1
#424 Level External RESET 0
#425 Enable of External Key 1 0: Disable,1: Enable
#426 Level of External Key 1 0 1: High; 0:Low
BOOL 1/00
BOOL 1/00
BOOL 1/00
1: High; 0:Low#427 Level of External Key 2
#446 Function of External Key 1 0:Start,1:Find Center
#447 Function of External Key 2 0:Pause,1: Zero
Para.
Mark
Parameter definition
Default
value
Parameter
Unit
Parameter
Scope
Notes
#437 Enable of X backlash 0 BOOL 1/0
0 BOOL 1/0
0 BOOL 1/0
0 BOOL 1/0
0:Disable,1:Enable
#438 Enable of Y backlash
#439 Enable of Z backlash
#440 Enable of A backlash
#441 Distance of X axis backlash 0 mm 0~200
0 mm 0~200
0 mm 0~200
0
0
mm 0~200
0~2000
#442 Distance of Y axis backlash
#443 Distance of Z axis backlash
#444 Distance of A axis backlash
#445 Speed of backlash mm/min
Set the backlash return as you need for
each axis.
Tip: experiment with the settings and
check the results
Para.
Mark
Parameter definition
Default
value
Parameter
Unit
Parameter
Scope
Notes
14 ) Other parameters(6 in total)
Note: For general G-code file, the
parameter can be set as 400. If the file
has many small segments, adjust the
parameter to be larger.
Interface response speed
while processing
Para.
Mark
Parameter definition
Default
value
Parameter
Unit
Parameter
Scope
Notes
#1 Language 1 BOOL 1/0 0: English,1: Chinese
#2 400-10000
#495 circle of interpolation 0.002
400
s 0.002-0.01 circle of interpolation
#250 enable of draw tool road 1 BOOL 1/0 0:disable 1: enable
#253 mode of draw 0 BOOL
N/A
1/0 0:statue mode 1:line mode
#499 user access key 888888 0-999999
Page -38Digtital Dream 4 Axis Motion Controller DDCS V2.1 User’s Manual
To Next Page
Loading...
