3–4 DECserver 90M Owner’s Manual
Table 3–1 (Cont.): DECserver 90M Troubleshooting
Problems Possible Causes Action
Printer does not print or Printer port and baud Reset printer and port baud rates
prints incorrectly. rate do not match. to match.
The printer port LED The printer is Connect the printer.
does not go on. disconnected.
The printer is not The port may be set Refer to the
Network Access Server
acknowledged by the incorrectly.
Problem Solving
manual.
printer port.
Check printer port Refer to the
Network Access Server
access.
Problem Solving
manual.
Flow control is not set. Refer to the
Network Access Server
Problem Solving
manual.
The power LED is on, The DECserver 90M Ensure LOADING is enabled on
the self-test OK LED cannot find the load the host. Reinstall the software to
is on, and the network image. replace the load image.
LED is blinking.
The port activity LED Port characteristics may Verify settings using the SHOW
does not blink when port be set incorrectly. PORT
n
command.
traffic is present.
To Next Page
Loading...
