Digital Equipment DECserver 700-08 User Manual

Part Number: EK-DSRVW-MG. B01
DECserver 700
Site Preparation and Maintenance
(Hardware Owner’s Manual)

Digital Equipment DECserver 700-08 Specifications

General

Model	DECserver 700-08
Type	Terminal Server
Network Interface	Ethernet
Connector type	RJ45
Protocols Supported	LAT
Power Supply	100-240V AC, 50-60Hz
Ports	8 asynchronous serial ports

Summary

Cabling the Site

3.2 Installing the Ethernet Cables and Devices

Instructions for connecting Ethernet cables and associated network devices.

3.3 Installing Serial Cables and Devices on the DECserver 700-16

Guidance for connecting serial cables and devices to the 700-16 model.

3.4 Installing Serial Cables and Devices on the DECserver 700-08

Guidance for connecting serial cables and devices to the 700-08 model.

Connector and Cable Pin Descriptions

4.1 Connector Pin Descriptions

Detailed breakdown of pin assignments for DECserver 700 connectors.

Replacing and Adding Memory

5.1 Replacing a Faulty Single-In-Line Memory Module

Step-by-step guide for replacing a faulty memory module.

Replacing and Adding Flash RAM

6.1 Replacing or Adding Flash RAM

Instructions for replacing or updating the DECserver 700 Flash RAM Card.

What to Do If You Have Problems

7.1 Diagnosing DECserver 700 Problems

Guidance for identifying and diagnosing common hardware issues.

7.2 Seven-Segment Display Off and System OK LED Off

Troubleshooting steps for no power or display issues.

7.3 System OK LED Off/Seven-Segment Display Flashing “C”, “d”, or "n"

Diagnosing SIM card failures based on display codes.

7.4 System OK LED Off/Seven-Segment Display Flashing

Troubleshooting non-operational hardware errors.

7.5 System OK LED Flashing

7.5.1 Error Message 952

7.5.2 Error Message 922

7.5.3 Error Message 941

7.5.4 Error Message 967

7.6 Seven-Segment Display Has a “3”

7.6.1 Downline Load Starts, Then Fails

7.6.2 Downline Load Does Not Start

7.7 Seven-Segment Display Codes