7–1
7
What to Do If You Have Problems
This chapter helps you identify and correct problems you may encounter during and
after the installation of the DECserver 700 hardware. The troubleshooting proce-
dures are for diagnosing and correcting hardware-related problems only.
Notify the network manager if the troubleshooting procedures indicate the problem
is software related or if the procedures do not correct the problem. Additional soft-
ware troubleshooting information is provided in the Network Access Server Problem
Solving manual.
Use the following to diagnose and troubleshoot the DECserver 700 problems:
• Seven-segment display
• System OK LED
• Console port messages
A full list of seven-segment display codes are shown at the end of this chapter. Refer
to the Network Access Server Management manual for the procedure to configure a
terminal to receive console port messages.
7.1 Diagnosing DECserver 700 Problems
Compare the state of the seven-segment display and the System OK LED with those
shown in Table 7-1 and go to the section indicated for information on corrective
action.
To Next Page
Loading...
