Storing the Program
• When you have the name how you want it, press the <Store> button again. The top line of the display reads:
Store To: [Program Name]
This screen allows you to select the location of the new program. Note that when the program is stored, it is stored in the User bank of
Programs because Factory programs cannot be overwritten.
1. Use the <2> knob or the <Program/Effect> wheel to select the User program number where you want to store the new
program.
2. Press the <Store> button again. The top line of the display briefly reads:
STORING PROGRAM TO ##
after which you are taken to the Program you just stored.
The newly created User program is now loaded, and can now be recalled at any time.
3. To abort the Store procedure, push either the <Program> button to take you to Program mode, the <Edit> button to take you
to FX Edit mode, or the <Utilities> button to take you to Utility mode, depending upon which mode you want to enter.
2120 VGS Artist
User Guide
Section - 3 Editing Programs
21
To Next Page
Loading...
