7. Use the <Page> knob to scroll to the next Dynamic modifier page.
8. Use the <1> knob to select which of the two Dynamic modifiers you want to adjust.
9. Use the <2> knob to adjust the attack time of the Dynamic modifier.
10. Use the <3> knob to adjust the hold time of the Dynamic modifier.
11. Use the <4> knob to adjust the release time of the Dynamic modifier.
Morphing/Volume Pedal Assignments
The 2120 VGS Valve preamp modules and the effect configurations within the 2120 VGS have special morphing and volume control capabilities
that allow you to morph between one preamp type to another. This will allow you to either morph from a distorted Tube distortion type, to a
clean Solid State preamp tone type or assign a volume pedal either pre or post digital effects. Morphing and Volume control can be done by
linking an Expression pedal to the Morph or Volume pedal parameter.
Morphing/Volume Assignments
To assign the Morphing/ Volume pedal to morph between distortion types or control volume, use the following procedure.
1. From Program mode, press the <Edit> button and then turn the <Program/Effect> wheel until The display appears something
like this:
2. Now turn the <Page> knob, and the display will appear like this:
3. At this point, you can select the position of the Volume pedal (Pre or Post Digital) or the Morphing pedal for assignment by
turning the <3> knob until the display appears something like this:
To Next Page
Loading...
