Assigning MIDI Control to the Expression Pedals
This series of menus and submenus allows MIDI setup of the Expression pedal(s) of the Control One. There are two procedures you must do
in order for the Expression pedals to work properly with MIDI:
1. Assign CC Number
2. CC Transmit Channel
Assign CC Number to Expression Pedals - This option allows you to choose the MIDI CC numbers you want to use for sending continuous
control messages using any one of the three Expression pedals options. From the factory, the Expression pedal(s) are not pre-assigned to any
MIDI CC number. To assign which CC number is sent from the Expression pedal(s), do the following.
1. Press the <Utilities> button once. The display reads something like this:
2. Turn the <Page> knob to page 11 of the utilities menu and the display reads:
3. Turn either the <2, 3 or 4> knobs to assign a CC number to the selected Expression pedal . The display will appear like this if,
for example Exp 1 is selected. (Exp1=Internal Expression pedal on 2120 w/o Control One. Or, Internal Expression on the 2120
FC when connected. The display now reads:
4. Press the <Utilities> button to exit.
For a complete explanation of Expression Pedal names, please refer to page 50.
CC Transmit Channel - This option allows you to set the MIDI channel on which CCs will be sent out the 2120 MIDI Out port to other MIDI
devices. If you are using the 2120 FC for the 2120 only, you don't need to worry about setting up this option.
To Next Page
Loading...
