Assigning CC Transmit Toggle
The procedure for setting up the CC Transmit Toggle function is as follows:
1. Press the <Utilities> button once. The display reads:
2. Turn the <Page> knob to page 10 until the display reads:
3. Turn the <2> knob to select the bank in which the CC toggle is to used. Once the bank is selected, use the <3> knob to select
the footswitch to be used. The display reads:
Note- Only footswitches currently assigned to control parameters in the 2120 VGS can be used for the CC
Transmit Toggle function
4. The display now shows that footswitch 6 in bank 1 is can be used to toggle CCs. Take notice that from the factory when
footswitches 6-0 can be used for the CC Transmit Toggle function.
5. Now to assign the CC number, just turn the function knob <4> until you have reached the desired CC. The display will now
read something like this:
6. Press <Utilities> to exit the Foot Controller setup menu.
To Next Page
Loading...
