Included Items
The DigiTech
®
Red Special Pedal includes the following items:
• DigiTech Red Special Pedal
• Red Special Artist Series Gig Bag
• Sixpence Plectrum
• PS0913B Power Supply
• This Owner’s Manual
• DigiTech Warranty Card
• DigiTech Brochure
Please make sure that all of these items have been included before you
get started.
Setup Directions
Follow these setup directions before use:
1. Turn the volume down on the amplifier/mixer you are connecting to.
2. Connect the pedal output to the amplifier/mixer input.
3. Connect the guitar to the pedal input.
4. Connect the power supply to the pedal.
5. Turn up your amplifier/mixer level to your desired listening level.
6. Turn the selected Model on or off by pressing the TOE SWITCH or
the HEEL SWITCH.
NOTE: To best utilize the built-in treble booster, plug your guitar directly
into the Red Special Pedal (instead of placing the Red Special Pedal at
the end of your effects chain). The built-in treble booster boosts the high
frequencies of the guitar signal and attenuates low frequencies. However,
it also has a relatively low input impedance which loads the guitar pickups
more than plugging into a high impedance input (like a a guitar amp). This
has the effect of rolling off a portion of the highs and smoothing out the
overall tone. Since this “loading” effect cannot be reproduced digitally, an
input loading circuitry is utilized along with digital modeling anytime the
signal path in the Red Special Pedal uses a treble booster effect.
To Next Page
Loading...
Need help?
General
