DigiTech Element XP User Manual

34
Technical Information
Factory Restore
The Factory Restore procedure will return the Element/Element XP to its factory default state.
WARNING! The Factory Restore procedure will reset all modified user presets and return them to
their factory default settings. This procedure is permanent and cannot be undone.
To perform the Factory Restore procedure:
1. Start with the power cable disconnected (unit powered down).
2. Press and hold the STORE button while connecting the power cable. When Fr appears in the
display, release the
STORE button then quickly press and hold the STORE button again for 3
seconds until
rSt appears in the LED display then release.
3. The Factory Restore procedure will be performed. Wait for it to finish. At this point the
Factory Restore procedure will be complete if using an Element. When resetting an Element
XP, you must proceed to step 4 to calibrate the Expression Pedal.
4. When tdn appears in the display (Element XP only), the Element XP's Expression Pedal is
ready to be calibrated. Rock the
EXPRESSION PEDAL forward (toe down) then press either
FOOTSWITCH.
5. When tuP appears in the display, rock the EXPRESSION PEDAL back (toe up) then press
either
FOOTSWITCH.
6. If the calibration procedure is successful, the Element XP will return to Play Mode and will be
ready for use. If the calibration procedure fails,
Err will appear in the LED display followed by
tdn. If this happens, repeat steps 4 and 5 until calibration is successful.

DigiTech Element XP Specifications

General

Expression Pedal	Yes
Input	1/4" instrument input
Output	1/4" Mono
Headphone Output	1/8"
Power Supply	9V DC
USB	No
Presets	100 (50 Factory, 50 User)