DigiTech RP150 - Compressor Effect; Compressor Model Parameters

21
Compressor
A Compressor is used to increase sustain, tighten up guitars, and prevent the signal from clipping
the input of other effects. It sets a maximum boundary for the strength of a signal.
Comp Model - Knob 1 selects one of two Compressor models:  (DigiTech
®
Compressor) or  (Based on a Boss
®
CS-2 Compressor/Sustainer). Press this knob to turn
the selected Compressor models on and off.
Sustain - Knob 2 adjusts the amount of sustain. Ranges from  to .
Tone/Attack - Knob 3 adjusts the tone for the DigiTech Compressor, or attack for the
Boss CS-2. Ranges from  to .
Compressor Level - Knob 4 adjusts the Level from the Compressor. Ranges from  to
.
Attack (X-Edit
TM
only for DigiComp) - Knob 4 adjusts the amount of time the
Compressor takes to respond to a signal that exceeds the threshold. Ranges from  to .