37
Optional Passive Volume/Continuous Control Pedal
Connect a passive volume or continuous control pedal to the RP150’s Control In jack to control
the RP150’s Volume, Wah, or Whammy™ in real time with your foot. Turn on a Wah or Whammy
model to control it with the optional pedal, or turn on both a Wah model and the Whammy model
to control both simultaneously. When a pedal is connected and neither a Wah nor the Whammy
model are activated, the pedal controls the RP150’s volume by default.
Factory Reset
This function resets the RP150 to its original factory settings. This procedure erases all custom
User presets, and recalibrates the Expression Pedal.
ATTENTION: Performing this function will erase all user-programmed data. All
such data will be lost forever! Be sure you want to erase the memory and start fresh
before continuing with this procedure.
The procedure for performing a Factory Reset is as follows:
1. Press and hold the
Store button while powering up the RP150.
2. When the display prompts you with , release the Store button, which is now flashing.
3. Press and hold the flashing Store button for 3 seconds until appears in the display and
release. The Factory Reset procedure takes approximately 15 seconds.
To Next Page
Loading...
Need help?
General
