45
RP360 / RP360 XP
Output Mode
This system parameter has two options: MONO
and STEREO� This parameter determines whether
the outputs are configured for mono or stereo
operation and is only available when a connection
has been made to the LEFT OUT or RIGHT OUT
connector� Changing this parameter will affect all
outputs�
Plexi-Drive 1
LOOPER READY
SYSTEM SETTINGS 1/4
FOOTSWITCH
MODE
OUTPUT
TO
OUTPUT
MODE
PRESET
STOMP
BANK
AMP
MIXER
MONO
STEREO
• MONO
Select this option when connecting to a single amplifier or mixer channel�
• STEREO
Select this option when connecting to two amplifiers or mixer channels hard panned left and
right�
NOTE: When no connection is made to the 1/4” LEFT OUT or RIGHT OUT connector, the
STEREO option will automatically be selected behind the scenes, providing stereo operation
when using the 1/8” HEADPHONE output or recording using the USB output�
To edit the OUTPUT MODE option:
1�
Press the SYSTEM button� Ensure you are on the first page in the System Settings menu,
indicated by 1/4 being displayed in the upper right-hand corner of the LCD display� If you are
not, press either the
SELECT knob or SYSTEM button repeatedly until the LCD display reads
1/4�
2� Turn the EDIT 3 (OUTPUT MODE) knob to select the desired option�
3� Press the BACK button or any FOOTSWITCH to exit the System Settings menu and return to
the Performance state�
To Next Page
Loading...
Need help?
General
