17
EQ
The RP500’s EQ helps further shape your tone with Low, Mid, and High controls.
Knob 1 - Press Knob 1 to turn the EQ on and off.
Low Level - Knob 2 adjusts the Low EQ level. Ranges from -12dB to
12dB.
Mid Frequency - Knob 3 selects the frequency that the Mid parameter adjusts. Range
Is from 300 Hz to 4000 Hz.
Mid Level - Knob 4 adjusts the Mid EQ level. Range is
from -12dB to 12dB.
High Frequency - Knob 5 adjusts the High EQ frequency. Range is from 2000 Hz to
8000 Hz
High Level - Knob 6 adjusts the High EQ level. Range is
from -12dB to 12dB.
Low Frequency (X-Edit
TM
only) - This parameter selects the Low EQ frequency. Ranges
from 60 Hz to 500 Hz.
Low, Mid, and High Bandwidth (X-Edit only) - This parameter selects the frequency
bandwidth for each frequency band. Range is from Narrow to Wide.
Noise Gate/Auto Swell
A Noise Gate is designed to eliminate noise while you are not playing, or provide an auto
volume swell effect.
Gate Type - Knob 1 selects between the DigiTech
®
noise gate or the volume swell effect.
Values include: (Selects the Noise Gate) and (Selects the Auto Swell effect.)
Press this knob to turn the Noise Gate/Auto Swell on and off.
Threshold (Noise Gate only) - Knob 2 sets the signal strength (Threshold) required to
open or close the Noise Gate. Parameters range from (opens easily) to (requiring
strong signals to open).
Attack Time - Knob 3 sets the attack time. Ranges from (shorter attack time) to
(longer attack time).
Release - Knob 4 sets the Release parameter. Ranges from to .
Attenuation - Knob 5 sets the Attenuation parameter. Ranges from to .
Swell Sensitivity (Auto Swell only) - Knob 6 sets the Swell Sensitivity parameter of the
Auto Swell. Ranges from to .
To Next Page
Loading...
Need help?
General
