9
is selected, the left button takes you directly to overdubbing. Connect or
disconnect the optional FS3X footswitch only when the TimeBender
TM
is turned
off.
Expression Pedal Input5.
Connect a mono (tip/sleeve) passive expression pedal to this input to morph
between two different delay settings. (Any volume pedal in the 100 kOhm – 500
kOhm range, with log taper, will work as well.) See page 16 for details on how
to use an expression pedal with the TimeBender
TM
.
Power Supply Jack6.
Connect the PS0913B power supply here.
Guided Tour - Rear Panel
To Next Page
Loading...
