DigiTech Whammy DT User Manual

Page 4
Making Connections
The Whammy DT pedal is extremely easy to set up and use. Follow these steps to get up and
running.
1. Connect your instrument to the instrument
Input Jack.
2. Connect from the Whammy’s
Output Jack to your favorite distortion pedal or to your
amplifier.
3. Connect from the MIDI out of a MIDI controller to the
MIDI In Port on the Whammy, if
desired.
4. Connect the power supply between an AC outlet and the
Power Jack on the Whammy.
5. Turn on your amp and adjust the volume to a desired level.
6. Using the
WHAMMY and DROP TUNE Footswitches to enable the desired effects, then
rotate the
WHAMMY and DROP TUNE knobs to select the desired Effects.
Output

DigiTech Whammy DT Specifications

General

Bypass Switching	True Bypass
Technology	Digital
Expression Pedal	Built-in
Whammy Effects	Yes
Detune Effects	Yes
Harmonizer Effects	Yes
Effect Type	Pitch Shifter
Inputs	1 x 1/4"
Outputs	1 x 1/4"
Power Source	9V DC
Features	Drop Tune, Momentary Switch
Pitch Shifting Range	+/- 2 Octaves