-31-
Function Description
By pressing and dragging the slider, you can setup the left panning limit (0º ~ 360º) of the PTZ
network camera.
Limit 2 When the locked target stops moving longer than the pre-defined tracking timeout, the camera
returns to the point it originally monitors after the preset tracking timeout.
By pressing and dragging the slider, you can setup the right panning limit (0º ~ 360º) of the PTZ
network camera.
Time When the locked target stops moving longer than the pre-defined tracking timeout, the camera
returns to the point it originally monitors after the preset tracking timeout.
By pressing and dragging the slider, you can setup pre-defined tracking timeout (5 ~ 60 seconds)
of the PTZ network camera or you can choose to have no time limit.
Apply After setup, click “Apply” to confirm.
Detection
Motion detection is used to generate a motion trigger whenever movement occurs in the video image. Select the
desired channel, and click “Edit” to enter the setting page of the motion detection area.
Function Description
Motion Detection
Setting Area
Set the motion detection area by selecting the area grids with your mouse. Pink grids represent
the area that is not being detected while the transparent grids are the area under detection. You
can set multiple areas under detection.
Select All Click “＋” (Select All) to set the whole area under detection.
Clear All Click “－” (Clear All) to set the whole area undetected.
Apply After setup, click “Apply” to confirm.
5.5 Tools
Click “ ” (Miscellaneous Control) → “ ” (Tools) to go into the “Tools” page.
Note: You need to be a supervisor to operate this function. For details, please see “Account” at page 18.
Update Firmware
In this page, you can upgrade the firmware version of your network camera.
To Next Page
Loading...
