-29-
Cruise
Click “ ” (Miscellaneous Control) → “ ” (Server Setting) → “Camera” → “Cruise” to go into the “Cruise”
page and access the following functions. In this page, you can setup the auto pan and sequence mode.
u Auto Pan (Check the “Auto Pan” checkbox)
Function Description
Left Limit By pressing and dragging the slider, you can setup the left panning limit (0º ~ 360º) of the PTZ
network camera.
Right Limit By pressing and dragging the slider, you can setup the right panning limit (0º ~ 360º) of the PTZ
network camera.
Pan Speed By pressing and dragging the slider, you can setup the panning speed (1 ~ 255) of the PTZ
network camera.
Apply After setup, click “Apply” to confirm.
u Sequence (Check the “Sequence” checkbox)
Function Description
Add Press “Add” button to enter the sequence anchor edit page and arrange the sequence of the
preset points.
In this page, select the preset point in the drop-down list of the “Preset No”.
By pressing and dragging the slider, you can setup the dwell time, pan speed, tilt speed and zoom
speed of the PTZ network camera. After setup, press “OK” to confirm.
Apply After setup, click “Apply” to confirm.
Example for the cruise function operation:
After setup the sequence of the preset points. In the PTZ control panel, press “AUTO” button and the PTZ network
camera will start cruising according to the pre-defined sequence.
To Next Page
Loading...
