5. L2 Management
5.1 MAC address table
Check the MAC address of the device mounted on the switch
5.2 VLAN Configuration
This page includes viewing VLAN State, VLAN Configuration, Voice VLAN Configuration,
MAC VLAN configuration and IP VLAN configuration.
Screen as blew:
The screen below shows the configuration of port VLAN;
Port properties that can be set:
Access：
Access ports are normally used to connect to end stations. Dynamic features like
voice VLAN may add the port to more VLANs behind the scenes. Access ports have
the following characteristics:
Member of exactly one VLAN, the Port VLAN (Access VLAN), which by default is 1.
Accepts untagged and C-tagged frames.
Discards all frames that are not classified to the Access VLAN
On egress all frames classified to the Access VLAN are transmitted untagged.
The access port is usually used to connect to the terminal station. For example,
To Next Page
Loading...
