5.3 GVRP
Enable the GVRP function, screen as blew:
The enabled GVRP function is applied to the designated port and configure its timer.
Used to view the operation information of GVRP.
5.4 Link Aggregation
On this page, you can configure static aggregation groups, dynamic aggregation
groups, and view link aggregation information;
Static aggregation configuration: click create static aggregation group TID value range
is (1-4), that is, up to 4 static aggregation groups can be created.
Port Member: Port join aggregation must be the same speed and full duplex
This switch supports 32 groups of aggregation, each group supports up to 8 ports. To
configure an aggregation group, just select the convergence port to the same line
To Next Page
Loading...
