group number, as shown in Figure 21: 1-2 ports converge in a group; 3-4 ports in a
group. Please keep configuration consistency for the ports of aggregation group
members, such as port rate mode, VLAN information, etc.
Link aggregation load balancing mode supports:
"Source MAC address" (load balancing calculation based on source MAC address of
message)
"Destination MAC address" (load balancing calculation based on the destination MAC
address of the message),”
"IP address" (the source IP address and the destination IP address of the message are
XOR, and then the load balancing calculation is performed)
"TCP / UDP port number" (load balancing calculation is based on the TCP / UDP port
number of the message).
Four modes can be selected and combined. The assignment of equalization algorithm
is global.
If LACP dynamic aggregation protocol is enabled on some ports, static aggregation
cannot be configured manually.
Note:
Static aggregation on the same port cannot be configured simultaneously with
dynamic LACP aggregation.
To Next Page
Loading...
