3. Port Management
3.1 Port Configuration
In this page, you can set the port rate, duplex mode, the max frame length (the value
range is 1518-10240), flow control and switch port.
In the link status, indicates that the port is not connected, or the port has been
manually down. When the link status is or , it indicates that the port is
working normally, the color is the port working mode (green is Gigabit, yellow is
100MB).
On this page, you can not only view the port link status and port working mode, but
also set the port working mode, such as "100MB full / half duplex", "Gigabit full / half
duplex" and "adaptive". You can also close the specified port through this page, which
is the same as the command “shut down”.
For the frame size setting, the default is basic frame 1522, which can be modified to
super long frame 9600. The value range of this item is 1518-10240.
3.2 Port Isolation
This page is used to configure the port isolated. The isolated ports cannot
communicate with each other, and the isolated ports can communicate with other
non-isolated ports.
To Next Page
Loading...
