Configure dynamic aggregation port as blew:
Link aggregation information: view switch aggregation port information.
The switch supports port dynamic aggregation. After enable the dynamic protocol of
the port, the devices on both sides of the convergence exchange information through
the protocol. According to the parameters and status of both sides, the matching links
are automatically gathered together to send and receive data. After the convergence
is formed, the switching equipment maintains the convergence link state, and
automatically adjusts or disbands the aggregation link when the configuration of both
sides changes.
The configuration parameters of dynamic protocol include protocol switch state, key
negotiation and active / passive mode selection. Only when the dynamic protocol is
turned on can the dynamic negotiation be carried out, which may lead to the
formation of aggregation links. The key is the basis of negotiation. Only the ports with
the same key can negotiate to form an aggregation link. The negotiation mode is
"active | passive". When "active" is selected, the device will actively initiate
aggregation negotiation; when "passive" is selected, the device will passively accept
the aggregation negotiation initiated by other devices. If some ports have been
converged statically, the dynamic convergence of LACP cannot be realized.
Note: dynamic LACP aggregation and static convergence on the same port cannot be
configured at the same time
To Next Page
Loading...
