7
3. Plug the HDMI connector into the HDMI port of any available HDMI port on
the switch by using a set of KVM cables corresponding to the product model.
4. Connect the corresponding HDMI video connector, USB connector of the
KVM cable to the corresponding PC port.
5. Plug the power adapter supplied with this package into the AC power
supply and plugs the other end of the power adapter into the power jack
on the switch.
6. Turn on the computer.
Note:
Make sure all plugs are connected to the same set of KVM port jacks
(all on port 1, or all on port 2).
8. Operation
Hot swap:
The DS-12910/DS-12911 supports hot plugging. Components can be removed
and added back into the installation by unplugging and replunging their cables
from their respective ports without the need to shut the switch down. For hot
plugging to work properly, the following procedure must be observed:
Hot Swap CPU Ports: When to plug or unplug the cable from the port, the cable
must be plugged back to the same port it removed.
Power off and reboot:
If it becomes necessary to power off one of the KVM unit, before starting it back
up you must do the following:
• Shut down all the computers that are attached to the unit.
Note: If the unit is operating under external power, unplug the power
adapter cable.
• Wait 10 seconds, then plug the power adapter back and power on all
computers.
Port selection:
The DS-12910/DS-12911 provides two methods to obtain instant access to any
computer in your installation: manual and OSD.
Manual:
Simply press the appropriate port selection switch on the DS-12910/DS-12911 ’s
front panel. After pressing the switch, the selected LED lights will indicate that
the port has the KVM focus.
To Next Page
Loading...
Need help?
General
