FAQ
Q: Transmitter and receiver can't be connected with each other?
A:
1) Please check if the wireless connection light on product blinks properly.
2) Restart the transmitter or receiver.
3) Reconnect the HDMI cable or use another HDMI cable to try again.
4) Please change the location of sender (TX) and receiver (RX) and make sure
devices are within the signal coverage.
Q: The Wifi LED indicator of the transmitter is off, but no signal output
on display/monitor?
A:
1) Please check if there is an HDMI signal input of sender TX
2) Try to connect the signal source directly to display device to see if there is
signal output from source device or change the signal source, the resolution
of input signal, HDMI cables to try again.
Q: Display is not fluent and stable
A:
1) Please change the location of sender (TX) and receiver (RX) and make sure
the device is within the signal coverage.
2) Restart the transmitter or receiver.
3) Reconnect the HDMI cable.
4) Remove other wireless signal disturbance and reduce the obstacle on the
way.
To Next Page
Loading...
Need help?
General
