Dimension One Spas Spa - Pump, Temperature, and Cartridge Settings

Dimension One Spas – Reflections Owner’s Manual
19
Pump Run Time
After you set the Number of Filter Cycles, the Display Window
will prompt you to “SET PUMP RUN TIME”. Push the UP or
DOWN Button to choose 30, 45 or 60 minutes. Push the
PROGRAM Button to save your setting. This sets how long the
pump will run when a Jets Button is pushed, before shutting
off automatically. The pre-set factory default is 30 minutes.
Temperature Units
(
 F or  C)
After you set the Pump Run Time, the Display Window will
prompt you to “SET TEMPERATURE UNITS”. Push the UP or
DOWN Buttons to toggle between F (Fahrenheit) to C
(Celsius). Push the PROGRAM Button to save your setting. The
pre-set factory default is Fahrenheit.
Vision Cartridge
After you set the Temperature Units, the Display Window will
prompt you to “SET VISION CARTRIDGE”. Push the UP or
DOWN Buttons to toggle between “Yes” and “No”. If your
spa has a Vision Cartridge select Yes, if not, select No.
Selecting “Yes” will tell the Message Center to notify you
when your cartridge needs replacement. Push the
PROGRAM Button to save your setting.
This ends the programming sequence for spas without the
Liquid FX option.
Water feature Run Time
(Liquid FX spas only)
After you set the Vision Cartridge, the Display Window will
prompt you to “SET WATER FEATURE RUN TIME”. Push the UP or
DOWN Button to choose 1, 2, 3 or 4 hours. Push the
PROGRAM Button to save your setting. This sets how long the
water feature will run when the Water Feature Button is
pushed, before shutting off automatically. The pre-set factory
default is 1 hour.
This ends the programming sequence for spas with the Liquid
FX option. Remember, during programming, you can press
Enter at any time to exit the programming sequence and
return to the main screen.