Dimension One Spas Spa - Setting Clock and Filter Cycles

Dimension One Spas – Reflections Owner’s Manual
18
Clock
After you press the PROGRAM Button for three seconds, “SET
TIME OF DAY” appears in the Display Window above the
scrolling instructions: “PUSH UP OR DOWN TO CHANGE - PUSH
PROGRAM TO SELECT NEXT FUNCTION - PUSH ENTER TO EXIT ”.
(If you’d like to skip setting the Clock, press Program to move
on to the Filter Start Time.) When you push the Up or Down
button, the Time screen appears with “Hours” (_ _.00)
flashing. Set the hour using the UP or DOWN buttons, then
push the LIGHT button to move on to the “Ten Minute”
setting (12:_0). Set it using the Up or DOWN buttons, then push
the LIGHT button to move on to the “Minute” setting (12: 0_).
Set it using the Up or Down buttons, then push the LIGHT
button to move on to the “AM or PM” setting. Select AM or
PM with the UP or DOWN buttons. When you are finished,
push the PROGRAM Button to exit the clock-setting mode.
You will then be prompted to set the Filter Start Time. If you
want to stop here, press Enter to exit the programming
sequence and save your changes. **If your model has a
Water Feature button, substitute the Water Feature button for
the Light Button in the above instructions.
Filter Cycle Start Time
After you set the clock, the Display Window will prompt you
to “SET FILTER CYCLE TIME”. Push the UP or DOWN Buttons, as
you did in setting the clock, to set the time you want your
filter cycle to start. When finished, push the PROGRAM Button.
The pre-set factory default is 12:00 p.m. to 1:00 p.m.
repeating every 12 hours unless the number of filter cycles
per day has been changed.
During a filter cycle, “SPA FILTERING” appears in the corner of
the Display Window. JETS 1 will run for 5 minutes at high
speed and for the remainder of the cycle at low speed. JETS
2 will run for 1 minute at high speed and then turn off.
Filter Cycle Duration
After you set the Filter Cycle Start Time, the Display Window
will prompt you to “SET CYCLE DURATION”. Push the UP or
DOWN Buttons to choose 60, 90, 120, 150 or 180 minutes.
Push the PROGRAM Button to save your setting. The pre-set
factory default is 60 minutes.
After you set the Filter Cycle Duration, the Display Window
will prompt you to “SET # OF CYCLES”. Push the UP or DOWN
Button to choose 1, 2, 3 or 4 cycles per day. Push the
PROGRAM Button to save your setting. The pre-set factory
default is 2 cycles per day.
Number of Filter Cycles
Long and/or numerous filter cycles could cause
overheating of the hot tub, especially in hot
climates.