Dimension One Spas Spa - Pump, Temperature, and Filter Settings; Digital Control Panel Warning Messages

Dimension One Spas – Reflections Owner’s Manual
23
Number of Filter Cycles:
Pressing the Program button the fourth time brings you to the
Number of Filter Cycles that your spa will run each day.
Your choices are 1, 2, 3, or 4 cycles per day. The factory default
is 2 times per day.
NOTE: Long and/or numerous filter cycles could cause overheating of the hot
tub - especially in hot climates.
Pump Run Time
Pressing the Program button the fifth time brings you to the Filter
Pump Run Time. Push the UP or DOWN Button to choose 60, 90,
120, 150, or 180 minutes. This sets how long the pump will run
when a Jets Button is pushed, before shutting off automatically.
The pre-set factory default is 60 minutes.
Temperature Units (ºF or
ºC)
Pressing the Program button the sixth time brings you to the
Temperature Unit selection.
Use the UP or DOWN Buttons to choose Fahrenheit (ºF) or Celsius
(ºC). The factory default setting is Fahrenheit.
Press the Program Button a seventh time to finish and exit the
programming sequence.
Warning Messages in the Digital Control Panel
Overheat Warning
If your control panel has flashing lights and an OH in the display,
your system has overheated. The water temperature has
reached 118 F (47.8 C). The entire system is disabled.
Contact your local Authorized Dimension One Spas Dealer, or
authorized service center.
Ice Warning
When ICE appears in the Display Window, the air temperature
has dropped below a factory-preset level, and the system has
activated “Smart Winter Mode.” The pump will automatically
run to circulate the water and prevent it from freezing.
This is a normal function and no action is necessary.