dimos DIPRO-P4600 - 11 Adjusting the Profiling Machine

- 15 -
15
11. ADJUSTING THE PROFILING MACHINE
DIMOS machines are all set up in the factory. It is strongly discouraged to change the
settings of the profiles. Before changing settings, please contact your supplier.
Adjusting underclock and overclock profiles:
The under and overclocks must be at the right height for perfect subsequent crimping.
 To increase dimensions:
 Unscrew A screws
 Unscrew screw B to create some give to adjust.
 Unscrew screw C to move the part to the desired value.
 Tighten the screw B to bring it back into contact.
 Tighten A screws
 To reduce the dimensions:
 Unscrew A screws
 Tighten screw C to create some give to adjust.
 Tighten screw B to move the part to the desired value.
 Unscrew screw C to bring it back into contact.
 Unscrew A screws
Carefully check the height of the profiles and constantly check these dimensions during production.
Adjustment of the output guide:
1) Unscrew clamping handle B
2) Adjust the height of the tensioner adaptor with wheel A.
 Clockwise to raise it
(1 turn = +0.25mm)
 Anticlockwise to lower it
(1 turn = +0.25mm)
EN
G
A
B
A
C
B