12. MAINTENANCE
A. General guidelines
- Observe the operating instructions of the machine: Always unplug the machine as soon as you leave
your workstation.
- Do not insert foreign objects into the machine.
- Respect the machine’s maintenance schedule.
- Regularly check the correct operation of your machine: check the general condition, if there are no
broken parts, if the profiling rollers are not dirty, if everything is mounted correctly.
- Check the condition of the power cables regularly.
All maintenance must be done with the machine turned off and disconnected from mains power.
The person working on the machine must be competent in the field of safety and risks related to maintenance.
Any casing disassembled for maintenance must be reassembled before restarting.
The profiling machine has been designed for minimal maintenance.
The drives are greased for life, therefore only mechanical gearboxes are to be serviced periodically, namely:
greasing the sprockets and drive chains of the tensioners, retighten the motor chains if necessary.
In case of interventions on construction sites, the machine must be protected against corrosion before and after
the work (spraying bare parts). Furthermore the machine must be protected by a suitable cover
B. List of wearing parts
The DIPRO-4600 has no wearing parts. Nevertheless, the forming rollers can wear out if the machine is not
used correctly.
It is recommended to clean the machine:
- when you change metal types (profiling rollers, stops),
- when you start work on a new site (profiling rollers, stops).
C. Maintenance to be performed regularly
▪ Disassemble the upper covers.
▪ Clean and lubricate the drive shafts.
▪ Check if the rollers have accumulated any build-up of residue, clean if necessary.
▪ Grease the transmission chains.
You must reassemble and screw on the top covers
before use!!!
To Next Page
Loading...