QUICK REFERENCE GUIDE
1. Prior to the fi rst use of the fi replace verify the following:
• Are the circuit breakers for the fi replace on?
• Are the light bulbs in your fi replace loose? (to check, follow the
instructions for replacing the light bulbs under the Maintenance
section of this manual)
2. The heater on your fi replace may emit a slight, harmless odor when
fi rst used. This odor is a normal condition caused by the initial
heating of internal heater parts and will not occur again.
3. If your heater does not emit heat, ensure the main switch is on, the
built-in thermostat is set above the current room temperature and any
wall switches for the unit are on. If this does not work, switch the unit
off for 5 minutes and try again. Consult operation section of your
practical users guide for further information.
4. The information regarding the model of your fi replace can be found
on the rating plate located on the side adjacent to the supply cord.
5. If you have any technical questions regarding the operation of your
fi replace, or require service for your fi replace contact Dimplex
Customer Service.
CONTENTS
PAGE 1 Important Instructions
PAGE 2 Model and Serial Number
Information
PAGE 3 Operation
PAGE 4 Maintenance
PAGE 6 Accessories
PAGE 7 Warranty
To Next Page
Loading...
Need help?
General
