4
HEATER THERMOSTAT CONTROL
To adjust the temperature to your individual requirements, turn the thermostat control clockwise all the
way to turn on the heater. When the room reaches the desired temperature, turn the thermostat knob
counter clockwise until you hear a click. Leave in this position to maintain the room temperature at this
setting. For additional heat, turn clockwise until you hear the click again and the heater will turn on.
NOTE
The heater may emit a slight harmless odor when fi rst used. This odor is a normal condition caused by
initial heating of internal parts and will not occur again.
THE TEMPERATURE CUTOUT SWITCH
The heater on this fi replace is protected with a safety device to prevent overheating. Should the heater
overheat, an automatic cut out will turn the heater off. The heater will re-activate once the heater has
cooled. The overheat cutout may be triggered if the fi lter is dirty. Follow fi lter maintenance on Page 6.
CAUTION
If the heater continuously resets, disconnect the power at the main service panel and call your local
dealer.
MAINTENANCE
WARNING
Disconnect all power coming to fi replace at main service panel before attempting maintenance or
cleaning to reduce risk of fi re, shock or damage to persons.
NOTE
Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental burning of skin.
TOOL REQUIREMENTS: Screwdriver
LIGHT BULB REPLACEMENT
Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark section of the fl ame or when the clarity and detail
of the log exterior disappears. There are four bulbs under the log set which generate the fl ames and
embers.
FIGURE 5
Level 1 Indicator
A. On Switch B. Off Switch
Level 2 Indicator
Level 3 Indicator
To Next Page
Loading...
Need help?
General
