How to fix Dimplex CAS400LNH flame effect not starting?
If the Dimplex Indoor Fireplace flame effect won't start, check if the mains plug is correctly plugged into the wall socket. Also, ensure the water tank is full and there is water in the sump. Verify that the low voltage connector is properly connected, and that the Transducer Unit is correctly positioned in the sump, sitting down into the molded recess.
Why is the Dimplex Indoor Fireplace flame effect too low?
If the flame effect is too low on your Dimplex Indoor Fireplace, the metal disc in the transducer might be dirty, or the wire from the Transducer Unit might be sitting over the metal disc. Clean the metal disc with the soft brush supplied, directing the wire to the back of the sump. Additionally, the air filter may need cleaning or repositioning.
What to do if Cd51 error is displayed on Dimplex Indoor Fireplace?
If the Cd51 Error is displayed on the remote control of your Dimplex Indoor Fireplace, it indicates a low water level. Refill the product with water, ensuring the water tank is full and there is water in the sump.
What to do if Cd57 error is displayed on Dimplex CAS400LNH remote control?
If the Cd57 Error is displayed on the remote control, and the Dimplex Indoor Fireplace won't operate with LEDs continuously blinking three times, ensure there are no leaks in the sump. Also, check that the floats are moving freely within the sump and that the product is level. This error indicates that the time from max level to min level is too short, or there are conflicting water level readings.
Why does my Dimplex CAS400LNH Indoor Fireplace have an unpleasant smell?
If there's an unpleasant smell when using your Dimplex Indoor Fireplace, it could be due to dirty or stale water, or using unfiltered tap water. Clean the unit as described under maintenance and use only filtered tap water.
Overview of the remote control and its buttons.
Identifies causes and corrective actions for the flame effect not starting.
Explains the cause and solution for the Cd51 error code.
Diagnoses issues when the product fails to operate and LEDs blink.
General| Model Number | CAS400LNH |
|---|---|
| Category | Indoor Fireplace |
| Manufacturer | Dimplex |
| Type | Electric Fireplace |
| Fuel Type | Electric |
| Voltage | 120 V |
| Wattage | 1500 W |
| Heating Area | 400 sq ft |
| Control | Remote Control |
| Thermostat | Yes |
| Depth | 11.5 inches |
| Finish | Black |
| Overheat Protection | Yes |
| Heating Capacity | 400 sq ft |
| Flame Effect | Yes |
| Log Set | Yes |
To Next Page