Dimplex Evolve 50 - Page 19

19
Operation
Standby
Press
to turn on the unit or to put it in standby mode.
When the unit is turned back on, it will retain the previously used settings.
Flame Effect
Press
to turn the ame effect and media on or off.
Heat
Press
to turn the heat on or off. The replace will beep once and the icon will
remain on the display when activated.
The replace can be operated in heat only mode by turning off the ame and color
effects.
Heat Disable
Press and hold
and at the same time for 3 seconds to disable or enable the heat
function. This action must be performed on the hidden touch controls.
When the heat is disabled and either the
, , or is pressed, --- will appear on the
display.
Temperature
Increase
Press
to increase the temperature setting.
Temperature
Decrease
Press
to decrease the temperature setting.
The temperature can be set from 7°C to 30°C (45°F to 86°F).
When the temperature setting is adjusted, the set temperature will ash for 2 seconds,
then the ambient room temperature will be displayed briey.
Temperature
Display
(°C ↔ °F)
Press and hold and at the same time for 3 seconds to toggle between Fahrenheit
and Celcius. This action must be performed on the hidden touch controls.
Flame Speed
Press
repeatedly to cycle through the 5 different ame speeds.
Heat Mode
Press
repeatedly to cycle through the 4 different heater modes:
Normal: The element will automatically adjust itself to achieve and maintain the set
temperature.
Heat Boost: The element will work at maximum power for 20 minutes, then revert to
normal heater mode.
Eco: The element will work at reduced power to save energy.
Fan: The element will turn off and only the fan will run.
Mood Themes
Press
repeatedly to cycle through the 8 different Moods, which are different color
options for the media bed lighting.
1 - White
2 - Blue
3 - Violet
4 - Red
5 - Green
6 - Prism — media cycles through colors
7 - Kaleidoscope— media and accents cycle through colors at different rates
8 - Midnight mode — media is off
Press and hold to turn the media accent lights on or off.
Custom Color
Freeze the media and accent lights to a custom color.
When in Prism or Kaleidoscope modes (see Moods), press
while the desired color is
displayed to freeze the cycle on that color.
Press again to resume the color cycle.