21
Remote Control Battery Replacement
1. Remove battery cover of the remote control using a Philips screwdriver.
2. Correctly install the 3 Volt (CR2032 or similar) battery in the battery holder with
the + side facing up.
3. Secure the battery cover using the previously removed screw.
Batteries must be recycled or disposed of properly. Check with your Local
Authority or Retailer for recycling advice in your area.
Cleaning
Mirrored Glass Cleaning
The mirrored glass is cleaned in the factory during the assembly operation. During shipment, installation, handling,
etc., the mirrored glass may collect dust particles; these can be removed by dusting lightly with a clean dry cloth.
To remove ngerprints or other marks, the mirrored glass can be cleaned with a damp cloth. The mirrored glass
should be completely dried with a lint-free cloth to prevent water spots. To prevent scratching, do not use abrasive
cleaners.
Fireplace Surface Cleaning
Use only a damp cloth to clean painted surfaces of the fireplace. Do not use abrasive cleaners.
The replace should not be operated with an accumulation of dust or dirt on or in the unit, as this can cause a build-
up of heat and eventual damage. For this reason the heater must be inspected regularly, depending upon conditions
and at a minimum yearly intervals.
Servicing
Except for installation and cleaning described in this manual, an authorized service representative should perform
any other servicing.
Maintenance
WARNING: Disconnect power and allow heater to cool before attempting any maintenance or cleaning to
reduce the risk of re, electric shock or injury to persons.
Figure 21
To Next Page
Loading...
