19
Operating Instructions
Refueling
wood can be placed on the hot coals to be reignited.
1. Open air control before opening door.
2. Rake / break up any existing coals.
3. Load the wood with the length orientated front to back.
4. Best results will be achieved by loading several smaller pieces of wood rather than one large
piece.
5. Close door with air control fully open, and leave for minimum of 10 minutes to allow the fresh
wood to catch.
6.
Burning Tips
1. Use wood with a moisture content of less than 25% (dry basis). Logs should not feel moist or
damp, or have moss and fungal growths.
2. Symptoms related to wet wood:
• Low heat output
3.
FLUE DRAFT
1. To remove smoke, gases and fumes from the appliance.
2.
• Trees or other buildings nearby causing turbulence
• High and gusty winds
• Outside temperature and weather conditions
code inspector for more information.
To Next Page
Loading...
