7
Installation
SAFETY NOTICE:
violates ANSI NFPA 211 (USA) and CSA B365 (Canada).
Components
After unpacking your N65 stove, ensure that the parts listed below are included inside the stove
• 2 Refractory Bricks:
" x 1")
(10 ¹/" x 6 ¹/" x 1")
" x 5 ¹/" x 1")
• 2 Firebrick Retainers (LH & RH)
• Ash Pan
• Door Handle Extension
• 4mm & 5 mm Hex Keys
Assembling the Stove
POSITIONING THE TOP PLATE
Remove the 8 mm (
5
/
16
") thick top plate from the box and place on top of the stove locating the hole
POSITIONING THE ASH PAN
the base cabinet. The ash pan should slide all the way back, enough so that the door can then be
closed.
DOOR HANDLE EXTENSION
The stainless steel handle of the door will become hot during operation of the stove. The door handle
extension is packed along with the stove, which can be inserted at the bottom of the door handle to
open and close the door during operation. The door handle can be stored in the extension holder
bracket located in the top right corner of the stand.
Positioning the Stove
The stove must be placed so that no combustibles are within or can swing within 36" (914 mm) of the
front of the stove (doors, drapes, etc)
See the Clearance to Combustible Material section for minimum clearances to combustibles, i.e.
drywall and furniture.
To Next Page
Loading...
Need help?
General
