IMPORTANT
During the initial operation some odour may be noticed due to the newness of
materials used in manufacture. This is normal and will disappear after a short period
of use. It is however advisable to keep the room well ventilated.
Clean the outlet grilles and adjacent surfaces after the • rst operation as some dust
may be produced when the heater is • rst used.
In cases where unauthorised persons may
tamper with the control settings it is possible
to set a tamper-proof feature at the time
of installation, by pressing and holding the
Back button and the Enter simultaneously
for three seconds, ‘Child Lock’ will appear
on the screen, repeat to reverse. See the
Operating Instructions for further details.
Slave Mode
If more than one heater is installed in the
same room it is recommended that the
largest capacity heater is set as the master
and all smaller capacity products are set as
slaves.
Press Menu, Back and Enter for 3 seconds
to enter the service menu, select ‘Slave
Mode’ and press Enter. Select ‘Enable’.
Information
For cleaning, heater guards or other sales
service and Dimplex contact details please
refer to the back page of these Instructions.
Choosing and Setting a Mode
Sla v e Mode
Dis a bl e
Ena b le
Ser v ic e Men u
Cha rg e T im e
Sla v e Mode
Lan d lo rd Lo ck
Rm Te m p Offs e t
Ch ild L ock
31
To Next Page
Loading...
Need help?
General
