MAINTENANCE SCHEDULE
Read and understand all the warnings and
instructions before starting any maintenance
operation.
Before carrying out any maintenance
operation, make sure all the scheduled actions
have been carried out as planned.
A Every 10 hours of operation or daily
A-1 Visual inspection - checking
A-2 Engine oil level - check
A-3 Coolant level - check
A-4 Telescopic boom sliding blocks - check
A-5 Auxiliary pump - operating test
A-6 Overload sensor - check
B Every 50 hours of operation or
every 2 weeks
B-1 Transmission shaft - lubrication of
universal joints
B-2 Axles - lubrication of oscillation bushes
B-3 Hydraulic oil level - check
B-4 Telescopic boom sliding blocks -
lubrication
B-5 Fuel pre-filter - draining the water
B-6 Turret rotation slewing ring gear -
lubrication
B-7 Wheels - check tightening of nuts
B-8 Radiator - cleaning by rotating
reversely
C Every 250 hours of operation or
every 3 months
C-1 Transmission belt - check
C-2 Differentials oil - check
C-3 Wheel reduction gears oil - check
C-4 Steering elements - lubrication
C-5 Turret rotation slewing ring gear -
check reduction gear oil level
D Every 500 hours of operation or
every 6 months
D-1 Hydraulic oil filter - replacement
D-2 Engine oil and filter - replacement
D-3 Fuel pre-filter - replacement
D-4 Engine radiator - cleaning
D-5 Turret rotation slewing ring gear -
check tightening of bolts
E Every 1000 hours of operation or
every year
E-1 Fuel filter - replacement
E-2 Air filter - replacement of primary
cartridge
E-3 Differentials oil - change
E-4 Wheel reduction gears oil - change
E-5 Telescopic boom sliding blocks - adjust
the play
E-6 Turret rotation slewing ring gear -
change reduction gear oil - check play
E-7 Overload sensor - calibration
F Every 1500 hours of operation
F-1 Fuel filter - clean mesh element
G Every 2000 hours of operation or
every 2 years
G-1 Hydraulic fluid - change
G-2 Air filter - replacing the safety cartridge
To Next Page
Loading...
