return back at the moment of interruption
of power supply.
5 It returns back to main interface, when the
button is depressed.
6 After continuing for 5 minutes, recover the
above settings.
Work on the transmission belt only with the
engine stopped! After repairs, make sure
all the protection devices have been
refitted and that no tool has been forgotten
on the engine.
Checking the belt tension
1 To check the tension of the belts, lower
the arm of indicator (1) in the tester.
2 Place the guide (3) between two pulleys
on the V-belt (2). At this point, the stop
must be on the side.
3 Press button (4) in the RH corner with
respect to V-belt (2) uniformly until the
spring clicks audibly.
4 Lift the tester gently, without modifying the
position of the indicator arm (1).
5 Read the value measured on the
intersection point (arrow), scale (5) and
indicator arm (1).
Correct the tension if necessary and repeat
the measurement.
The belt tension tester can be ordered through
the Customer Service.
To Next Page
Loading...
